Electrodeposited homojunction Cu2O solar cell on FTO substrate

Abstract

Cuprous oxide (Cu2O), an abundant photoactive semiconducting material has optimum optoelectronic properties to develop efficient, inexpensive and eco-friendly solar cells. Even though, it is possible to fabricate Cu2O based hetero or Schottky junction solar cells, it is believed that the reduction of interface strains via application of surface treatments can produce best efficient homojunction Cu2O solar cell. Apart from the homogeneity of a p-n junction, reduction of contact resistances of a solar cell also has a great impact on its overall performance. Previous studies have shown that, annealing and/or sulphidation of thin film Cu2O enhances the surface properties while sulphided p-Cu2O/Au junction exhibits ohmic behavior as well. Thus, in this study possibility of developing efficient thin film homojunction Cu2O solar cell on FTO substrate was tested by improving the surface properties of n- and p-Cu2O thin film layers. n-Cu2O thin film was potentiostatically electrodeposited in a three electrode photoelectrochemical cell, contained 0.1 M sodium acetate and 0.01 M cupric acetate, acetic acid at bath pH value of 6.1 and then, this thin film FTO/n-Cu2O photoelectrode was annealed at temperature of 4000C to form very thin p-Cu2O layer with lower surface defects. Subsequently, for a thicker absorber layer a thin film ptype Cu2O was electrodeposited on annealed FTO/n-Cu2O photoelectrode using a lactate bath, consisted 3 M lactic acid, 0.4 M copper(II) sulphate and 4 M sodium hydroxide at bath pH value of 13.0. Finally, to form ohmic back contact this bi-layer is directly exposed to ammonium sulphide vapor for 8s and sputtered thin film of Au on it. Photoresponses and modulated light induced current-voltage characterization of this final thin film Cu2O homojunction is given the highest VOC and JSC values of 154 mV and 3.905 mA/cm-2 respectively. This result revealed that application of surface treatments to the thin film n-Cu2O and the bi-layers ameliorates surface properties, thereby the optoelectronic properties. Parameterization of surface treatments and improvements in the front contact will further improve this homojunction solar cell.